I’ve spent a lot of time working with making rubbing plates. Here’s one of the reasons. There are ways to make waves out of sheers and lame, or stitchery, but I want that feeling of white foam and spray.

It’s pretty. But it lacks definition. I can approach this with thread and/or sheer applique. It’s also a test case for my cranes.

This is what I’m aiming for. I’d rather not make my mistakes here. I’m waiting on some beach grass stencils to finish off this top. But I’m still unclear how I want to treat my water.

The two pieces give me the opportunity to try different ideas and compair them. For Making Waves 1 I treated the white bits as different from the darker blues. I stitched it with 40 weight madiera metallic supertwist first. That was miserable. Sometimes Supertwist will work with a 90 topstitching needle and a lot of Sewer’s Aid. This wasn’t that time. I got about three stitches before breakage. That’s past my tolerance.

So I went to plan b

So instead. I stitched the white waves from the top with poly 40 weight. The stitching from the top marks the back Then I traced the stitching with #8 weight candlight, rainbow.

I like this a lot. I went back in after that and stitched the rest with matching poly 40#.

Making Waves 2 is my second possibility.I stitched the waves withpoly 40#. More subtle but I like it too.

I also tried two different approaches to my sheer overlays. For Making Waves 1

I used white and purple cheesecloth. I found it too clunky.

I like this treatment better. Metallic lace and white organza just blends in better.

So to recap. I like the thick threaded Candelight on the waves, 40 weight polyester on the darker sea, and metallic lace and organza on the waves. What do you think? What would you choose?

For more information about bobbin work, check out Arse Over Teakettle: The Stubborn Art of Bobbin Work