Lace Jellyfish, Step by Step

This is not the first time I’ve done three-D jellyfish. But I’ve tweeked what I did this time and I’m happier with the results. If you’d like to see the earlier attempt, they are at Jellyfish 3D Transparency

I wanted three-dimensional transparent jellyfish with opaque areas.

This technique depends on the stabilizers. But there are a number of different stabilizers that will work. They are made for very special purposes.

Stabilizer Sandwich

This time I made my stitching sandwiches out of a layer of Totally Stable for my drawing, Paper Solvy, lace or organza, and Badgemaster, All the stabilizers except the Totally Stable will dissolve out of the work. What I want when I’m done is a clean outline and edge, with some white areas and some transparent.

You can make an image just with your stitching. But you have to make sure all of the stitching connects with itsself or it will fall apart when the stabilizers are gone. Instead, I used commercial nylon lace and organza as the fabric

What do those stabilizers do?

Totally Stable: Iron-on, tear-away. Good surface for drawing a pattern
Paper Solvy: Paper-like, tearaway that provides stabilization without a hoop that will dissolve in water.
Badgemaster: Heavy-duty corn starch topping that dissolves in water.

The order of the sandwich was, from top to botton, Badgemaster, organza or lace, Paper Solvy, and Totally Stable. Snce we’re working upside down, Totally Stable drawing layer is on top where we can see it.

The threads I chose were a polyester white top thread and a Cristalyn white metallic in the bobbin. The metallic is more fragile, and that is why I have it in the bobbin. I chose white because the background is so dark, and I wanted them to shine out. All of the stitching is done from the back.

You’ll notice that I used 2 different magic markers for my drawings. That was an error. Even with all the stitching, the marker colors showed through. I don’t mind either the blue or the orange, but they don’t work together in the same piece.

The Stitching

These are all stitched free motion from the back.

Stitch Process

Outline the image. Freemotion zigzag.

Remove any of the Totally Stable parts you want to be see-through. Score them with a pin and pull them out.X

Use a straight stitch to texture the jelly.

Remove the excess Paper Solvy and Totally Stable from around the pieces.

Stitch around the edge with a zigzag to stabilize them.

Cut away all the excess stabilizer

I edge-stitch again just to give them a more solid edge.

The Paper Solvy and the Badgmaster need to be dissolved in hot water.

Badgemaster is starch. So I took the trimmed off scraps,dissolved them in water, and dipped the jellies to give them that hard starched edge. I dried them on freezer paper. Notice that the orange jelly is the one that was drawn in orange. I need to rethink my mmarkers.